Drilling Holes In Beach Stones To Use For Beads
Posted: Thursday, March 04, 2010
by Aftab Ahmed
http://www.3dleaks.com
When drilling beach stones, I would suggest you avoid the advice about buying the best drill bit you can find. When drilling stone, diamond bits wear out quickly, whether you buy the twisted ones (expensive) or the straight ones (far less expensive.) So go for the straight ones.
I'd suggest you go for the economy diamond cylinder drill packs from Rio . They come 25 in a pack and cost less than a buck each, compared to $2 or $4 each for twist bits. You can get through five or six stones with a single bit if the stones are not too hard.
Once you have a achieved a small divot, drill through the stone in with your cylinder diamond drill bit. Unless your stone is very small, avoid any bit less than 1 mm. The .75 mm bits have a tiny shaft and break often. The 1 mm bits have a reasonably strong shaft.
To make sure you don't drill through the bottom of your container, put a couple of pop sickle sticks under your stone. Hold the stone under water, on top of the pop sticks. Use clear water so you can see what you are doing. The top of the stone should be just barely under water. As you drill, a long tail of dust will drift off from your stone in the water. Press a little, pull back a little, and get a rhythm going. When you get 4/5ths of the way through, turn the stone over to see where the hole is going to come out. Mark it with a sharpie, knick that place with a ball bur and start drilling from the back. When the hole meets the other side, everything else becomes easy.
Widen the hole with successively larger (cheap) diamond drill bits, drilling under water. I find a 2.5 mm hole holds a nice rivet and makes a nice pendant.
This Article has been viewed 744 times. (Not updated in real-time.)
Top-level comments on this article: (2 total)There are not many articles without any links in the directory. This is one of them.
Interesting article. thanks for submitting.
We want your comments! If you can read this, you don't have javascript enabled, so you can't use this comment system. Please enable javascript.